Pressing the right mouse button on the Endpoint will open a dialog box that allows you to define parameters for the Pulse Counter:

·     Node Name: Enter a descriptive name that allows you to identify the Endpoint in your installation.

·     Scripts ID: this optional field will identify the Endpoint in the Scripts. You can enter a short name, ensuring that no two plans with the same ID.

·     Address: the system identifies the channel that owns the endpoint. In a device that controls various channels, the system will display the channel number assigned to the endpoint you are editing.

·     Type: in this case the system identifies the Endpoint with Infrared Transceiver.

·     Endpoints Group: This application will allow you to assign the Endpoint to a group previously defined. Then you can configure actions for the group.

Pulse Counter:

·     Measurement type: Here you can define what to measure.

·     Unit: set the unit of measure to use.

·     Units per pulse: According to the computers you use, specify the equivalence of the unit of measurement pulses.

Important: Once the pulse counter set, you must link each of the end points you want to get involved in the measurement.