All installations require a unit which allows devices to link to the Habeetat Planner application. The system provides two ways to perform this association, by means of HPA-6200 products and / or HPA-2400.

The HPA-6200 is the main autonomous control unit, equipped with Habeetat Planner Server application. It has a repeater and a built in 802.15.4 single pole antenna to establish links with the devices within the boundaries of the Habeetat network.

The HPA-6200 must be connected to the LAN network through the Ethernet port. To access the installation from any location a quick access Internet connection will be required.

The HPA-2400 is a USB interface that allows any PC to link with the Habeetat installation, replacing the Main Control Unit HPA-6200. This device must be connected to a computer or server which must have previously installed the Habeetat Planner application.
The HPA-2400 USB has a repeater and a single pole antenna 802.15.4built to link with surrounding devices of ZigBee network.

A quick access internet connection is required.

The installation of this module is connected to the PC's USB port to be used as a server. It is not necessary to discharge this device in the Habeetat Planner, but you must configure the network and the USB port from:
Home Menu / Tools / Preferences ... / Interfaces, select the Habeetat ZB (ZigBee) network, tick the Enable Habeetat ZB interface. Finally you must select from the dropdown menu USB port that is connected to the interface.

See Also: